This board contain everything needed to drive the CCD device and the connection between
the EtherIO
board and the internal electronic of Audine camera.
Picture of this board (click it to grow up) :
this picture shows EtherAudine board alone, components are on only one side but the printed circuit is double sided.
This board has been conceived to be compatible with most cameras working on parallel EEE1284 standard port and when we take technical documentations on them.
It's advised to reduce the parallel cable used to link this interface to the camera (it was the same for the direct binding between the computer and the camera). That's why we propose you shorter cables in the order form. You could also, find DB25 with rapid connecting clamp, cut yourself your 5 meters cable to obtain eventually one of 1.5 meters and one of 3.5 meters.
This card takes also a communication port compatible with I2C to speak each other with single peripheral (dating module will be available sooner). It is bind in way out on the same DB9 which we use for the RS232 connection. A specific cable is necessary following the practise. All the information on this cable and on programming of this port will be indicated in the documentation (and sooner on this internet site).
Sooner will be available a similar card for the hisis22 cameras (pre order) and for the KafAude camera (contact us).